Overdeed

Overdeed / Learn / NYC FAR Calculator

Zoning tool

NYC FAR Calculator

Estimate the maximum buildable floor area on a New York City lot — and the unused development rights (air rights) sitting above it. Enter the lot area, pick the zoning district, and add the existing building size to see what's left.

Max buildable floor area
—
Already built
—
Unused development rights
—

This is an as-of-right estimate, not an analysis. It uses the standard maximum residential FAR for each district. Real buildable area depends on overlays, Inclusionary Housing or other bonuses, community-facility FAR, height and setback rules, corner and zoning-lot conditions, and rights already transferred off the lot — which a map-level estimate can't see. Overdeed resolves all of that per block.

How the calculation works

Every lot in New York has a Floor Area Ratio (FAR) set by its zoning district. FAR is simply a multiplier on the lot's land area:

Maximum buildable floor area = lot area × FAR

So a 5,000 sq ft lot in an R6 district (FAR 2.43) permits about 12,150 sq ft of zoning floor area. If the building standing on it is only 7,000 sq ft, roughly 5,150 sq ft of development rights are unused — unbuilt capacity the owner is entitled to but hasn't used. That gap is what the market calls air rights.

Maximum residential FAR by district

These are the standard maximum residential FAR values in the NYC Zoning Resolution (Quality Housing where applicable). Commercial and manufacturing districts, overlays, and bonus programs use different numbers.

DistrictMax residential FAR

See the real number for your block

A calculator can't net out the rights already transferred away, the adjacent lots that can sell into your zoning lot, or who holds them. Overdeed resolves the full picture — base, over-base, nearby transferable rights, what's already moved, and remaining supply — per block.

Common questions

What is FAR in NYC zoning?

FAR, or Floor Area Ratio, is the multiplier the NYC Zoning Resolution applies to a lot's area to cap how much zoning floor area you can build. A 2.0 FAR on a 5,000 sq ft lot allows 10,000 sq ft.

Is FAR the same as buildable square footage?

Buildable square footage is the result of FAR — lot area multiplied by FAR. The actual enclosable area can differ because some spaces (cellars, mechanical, certain balconies) are excluded from zoning floor area.

How do I find my lot's zoning district?

Look up the address or BBL on NYC's ZoLa (Zoning & Land Use) map or the Department of City Planning's records. Many lots also carry commercial overlays that change what's allowed.

Can I build all my unused FAR?

Not always. Height factor, setback, lot coverage, and other envelope rules can stop you from using every permitted square foot on-site — which is one reason unused rights are sometimes transferred to a neighboring lot instead.

Overdeed provides development-rights data and analysis. It is not a licensed real-estate broker and does not appraise property or quote a dollar value for development rights. FAR values are summarized from the NYC Zoning Resolution and may change; verify against the current Resolution and a zoning professional before relying on them.